elumo is designed to be simple to connect by a suitably skilled installer due to the following features:
Hub, Reader and wired electric lock (not supplied, max. 1.2A @ 12V DC) can be powered by a single PoE+ switch port over standard CAT5 or higher ethernet connection providing internet connectivity.
elumo also supports the following advanced installation features should they be required:
Door Monitor and Request for Exit inputs
12V DC power supply input
Dry lock relay
Optional 8x8 external relay support (not supplied)
Standard Installation
Connect elumo Hub to PoE+ ethernet switch port with internet access
Connect elumo Reader to elumo Hub using supplied 3m cable
Connect electric lock to elumo Hub wet relay (1.2A max. @ 12V DC):
electric strike
Use Ground and NC relay connections
Connect door monitor input (optional - required for door forced/held alarms)
electric magnetic lock
Use Ground and NC relay connections
Connect door monitor input (optional - required for door forced/held alarms)
Connect Request-for-Exit button input
Advanced Installation
The elumo Hub may be powered via 12V DC instead of PoE+ if required
The electric lock may be controlled via the elumo Hub's dry relay if required (2A max. @ 30V DC)
Auxiliary 8x8 relay board may be connected via 10-way IDC connector
It is the installer’s responsibility to satisfy all local building code or emergency exit regulations in relation to electric locks.